Transcript
(M) MaherBot Spool Diameter Spool Width Spool Hub Hole Filament Diameter Shipping Weight Net Weight COMPATIBILITY Replicator 2 AND EARLER MODELS Replicator Mini Replicator ST GENERATION MODEL Replicator Z18 Makerbot PDF doc. DIMENSIONS & WEIGHTS SMALL 15.0 cm (590 in) scm 157 37 IM | 5.08 ст (2 in) 175 mm 0) 45 Ka (115) rt 77 La LL MA (0.50 15) SMALL LARGE в. ст (9.84 in) Som \ LJ 508 on (2 in) LARGE Ki 2.54 cm (iin) L75 mm 4 49 Y = 453 ка (10 Ib) XXL 1KG Every filament color is comprehensively quality tested at both 100-micron and 200-micron layer resolutions on the MakerBot Replicator 2 to verify that the filament wil. perform every feature that MakerEot MakerWare and MakerBot Decktop software offer If you're new to 3D printing. MakerBotl PLA Filament is a good material to start with because it's easy to use and performs well on most prints. MakerBot PLA Filament adheres well to acrylic and toc MakerBot Build Plate Tape. Prints wth a large bottom layer may have a tendency to curl. To prevent curling, use rafts. NAKERBOT REPLICATOR {57 GENERATION MODEL y O E 1