Download NuTone XN50 Instructions / Assembly

Page 3
XN50 n XN80 n XN110 Installation Guide
New Construction Installation
Tools needed
Materials needed
• Power screwdriver with a Phillips bit
• Phillips screwdriver
• 6" round metal ducting recommended for best performance.
Use of other ducting is acceptable but may impact performance.
• Flathead screwdriver
• Roof cap or wall cap (built-in damper recommended)
•Pliers
• Tape to seal duct connections
• Wire insulation stripper
• Electrical wiring and supplies per local code requirements
• Wire cutter
1 Remove Packaging
Punch out Mask from
packaging. See Step 6.
Remove
Instruction
Sheet
Parts Bag holds
Knockout Plate
and six (6)
screws
2
2
Install
Mounting
Frame
1
4
3