Transcript
Stainless Steel Technical Specification Toothbrush & Soap Holder Stock Numbers: P1740 – Toothbrush Holder Stainless Steel Finish Concealed Screw Mounting P1760 – Soap Holder Stainless Steel Finish Concealed Screw Mounting Materials: Toothbrush and Soap Holders are stamped from Type 304 stainless steel. P1740, P1760 Dimensions: Installation Instructions: 1. Remove mounting bracket from back of fixture by loosening the set screw. 2. Position unit on wall in desired location. 3. Lightly mark the outline of the base of the unit. 4. Center mounting bracket inside the outline. 5. Mark hole locations. Attach bracket to wall using 1 3/8” screws (provided). 6. Mount base on bracket. Tighten set screw on the bottom. Note: Wood blocking is preferable behind all wall surfaces. If wood blocking is not available, the following optional fasteners are suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall – Toggle Bolts. Cleaning Instructions: To preserve the fine finish of this product, clean only with a soft damp cloth. Dry well. Do not use commercial or abrasive cleaners. Stock Number:________________Soap Dish & Tumbler By Creative Specialties 2 5 3 0 0 A L MO E N D R I V E N O R TH O L MS TE D , O H 4 4 0 7 0 C O R P O R A TE H E A D Q U A R TE R S : ( 8 0 0 ) 3 2 1 - 8 8 0 9 F A X: ( 8 0 0 ) 8 4 8 - 6 6 3 6 I N TE R N A TI O N A L : ( 4 4 0 ) 9 6 2 - 2 0 0 0 F A X: ( 4 4 0 ) 9 6 2 - 2 7 2 6 C U S TO ME R S E R V I C E ( U S A ) : 8 0 0 - 8 8 2 - 0 1 1 6 F A X: ( 8 8 8 ) 3 7 9 - 2 7 2 0 W W W . MO E N . C O M Copyright Creative Specialties International Literature #BA1655
