Transcript
Assembly Instructions Bianca Floor Lamp Base # BFS010 (shade sold separately) No special tools are needed to install this portable lamp. Be sure to follow the steps in the order given. If you are unclear as to how to proceed, consult a qualified electrician. IMPORTANT SAFETY INSTRUCTION To prevent shock, only plug in unit after complete assembly. Do not exceed the maximum wattage rating. Before turning on the lamp, please follow the instruction step by step. Note: This portable lamp has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not attempt to work around this safety feature. Finial Shade Max. 26W spiral fluorescent bulb (included) Stem Socket Socket Base Nipple INSTALLATION Decoration STEP 1: Secure the lower rod onto the connector of the base. Secure the middle rod onto the connector of the lower rod. Secure the upper rod onto the connector of the middle rod. Secure the decoration to the upper rod with the connector. Secure the socket base to the decoration with the nipple. Connector Upper Rod Connector STEP 2: Screw the short threaded side of the stem into socket base tightly. Middle Rod STEP 3: Install bulb spiral fluorescent bulb, Maximum 26 Watts. (Bulb included) Connector STEP 4: Place shade onto stem, and secure it with finial. A 17" barrel is recommended with this base. (Shade sold separately) CLEANING To clean, wipe the lamp with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper. Lower Rod Base C Connector UL R Note: Sketch not drawn to scale
