Transcript
Assembling Your Old World Fountain Caution: Keep children and others from climbing, sitting, or leaning on the fountain and its components. Failure to do so could cause serious injury. Fountains have no interlocking component parts. Fountain parts are held by gravity only. MATERIALS LIST: -Pump -Hose -4' Level -Plastic Shims or Metal Washers - Silicone or Fountain Putty ASSEMBLY INSTRUCTIONS: 1. Place bowl (A) on level, firm foundation. Use a level and shims to assure bowl is level. 2. Place pump into pump cavity in bowl (A) and attach hose. Drop Electrical cord over side of bowl (A) in cord slot. 3. Align top set on base bowl (B). Push hose from pump through hole in middle of tallest bowl (C), level and shim if needed. Fill around hose tubing with putty to keep water from running back down hole. 4. Cut of excess hose. 5. Fill fountain with water, plug into 110 volt GFI outlet. 6. Pump has a flow control slide switch which can be adjusted to modify water flow to reach desired volume. C B A Contact: [email protected]
