Transcript
Assembling Your Patio Fountain Caution: Keep children and others from climbing, sitting, or leaning on the fountain and its components. Failure to do so could cause serious injury. Fountains have no interlocking component parts. Fountain parts are held by gravity only. MATERIALS LIST: -Pump -Hose -4' Level -Plastic Shims or Metal Washers ASSEMBLY INSTRUCTIONS: 1. Place Pedestal (A) on level, firm foundation. 2. Balance bottom bowl (B) on pedestal (A) Use a level and shims to assure bowl is level. 3. Place pump into pump cavity of bowl (B). Position electrical cord in slot outside pump cavity. 4. Center bowl (B) over pedestal (A) 5. Align boy topper (C) over pump cavity. Push hose from pump through hole in middle of topper. The hose needs only to go in a few inches. 6. Fill fountain with water. Plug pump cord into 110 volt GFI outlet. 7. Pump has a flow control slide switch which can be adjusted to modify water flow to reach desired volume. C B A Contact: [email protected]
