Download Home Decorators Collection 7474800310 Instructions / Assembly

 HOME
DECORATORS
COLLECTION
INV#74748
SK18157 ELIXIR SHORT STORAGE CABINET 35"HX15.25"WX15.25"D
ASSEMBLY INSTRUCTIONS
Made In China
Thank you for purchasing this quality product. Be sure to check all
packing material carefully for small parts, which may have came
loose inside the carton during shipment. Count all parts and material
present. If any parts are missing or damaged, please contact our
Customer Service Department for efficient and speedy service.
Please indicate the model number and code letter of part(S) needed.
IMPORTANT NOTE:Follow instructions listed below in proper
sequence as numbered to assure fast,easy and correct assembly.
PARTS LIST
© = Г
7
=
La
Back board - 1PC > Front door - 1PC > Right Panel - 1PC
e © ®
2
Left Panel - 1PC Bottom shelf - 1PC Top cap - 1PC
—2/15——
Shelf - 3PCS
Tempered glass- 2PCS
Glass protector- 2PCS
©
Ur:
Ч 7.
Foot knob - 4PCS Metal screw - 18PCS
©
Door knob - 1PC
Rectangle metal plate
- 2PCS
plastic anchor - 1PC
Ss
SH»
o
1-1/2" metal screw -1PC
Plastic band - 1PC
—3/15——
FIG 1
T=
~~
7
(-
e
©
©
e Screw 4 foot knobs(10) onto back board (1) and front door (2)
—— 4/15 — m
e Screw right panel (3) and left panel (4) onto front door (2) with 6 PCS metal
screws (11)
— 5/15 ——
FIG 3
e Screw the assembled piece onto the back board (1) with 6 PCS metal
screws (11) and adjust foot knob level
— 6/15 ——
FIG 4
e Screw bottom shelf (5) onto bottom of cabinet with 4 PCS metal screw (11)
— 7/15 ——
FIG 5
ADN
N =—
1°
VA
3)
(1
2) with 1
ob (1
FIG 7
e Insert 2 PCS glass protector (9) to protect the tempered glass.
—10/15——
e Slide top cap (6) onto the top of main cabinet.
—11/15——
e
F -— =.
| С О 7 >
7 >
e Tighten one of the rectangle metal plates (14) to top cap with metal
screw (11) on the back of cabinet using a Philips screwdriver.
—12/15—
FIG 10
e Tilt and place the shelf (7) on the shelf holder.
Be sure the bigger gap is in the front.
—13/15—
FIG 11
e Place the cabinet at desired position by the wall. Mark the insertion point for
the plastic anchor (15) on the wall. Using the proper hardware for your wall
type, drill 1/4" hole.
e Tighten another rectangle metal plate (14) to the plastic anchor (15) by using
the 1-1/2" metal screw (16).
—14/15—
FIG 12
e Using the plastic band (17), connect two rectangle metal plates (14).
—15/15—