Download Weider WEEVSY0923 User's Manual

Transcript
12. Lubricate two Small Wheels (47) with grease. Slide
a Steel Tube (57) into a 32mm Spacer (46). Orient
the Wheels as shown in the inset drawing, and
slide them onto the ends of the Steel Tube.
12
13
Wheel
Assembly
Attach the wheel assembly to the indicated set of
holes in the Seat Carriage (12) with an M8 x
84mm Bolt (60) and an M8 Nylon Locknut (65). Do
not overtighten the Locknut; the Small Wheels
(47) must pivot freely. Repeat with another
wheel assembly and an M8 x 82mm Bolt (95).
95
60
65
Small
46
Side 57
12
47
Orient the Seat (13) and the Seat Carriage (12)
as shown. Attach the Seat to the Seat Carriage
with four M6 x 16mm Screws (82).
47
82
Large Side
Wheel
82 Assembly
65
13
60
13
13. Lubricate two Small Wheels (47) with grease. Slide
a Steel Tube (57) into a 32mm Spacer (46). Orient
the Wheels as shown in the inset drawing, and
slide them onto the ends of the Steel Tube.
45
65
12
5
Set the Seat Carriage (12) on the Bench Frame
(5). Have one person press the Seat (13) against
the Bench Frame. Press the wheel assembly tight
against the bottom of the Bench Frame and attach
it to the lowest set of holes in the Seat Carriage
with an M8 x 84mm Bolt (60) and an M8 Nylon
Locknut (65). Do not overtighten the Locknut;
the Small Wheels (47) must pivot freely.
Adjustment
Hole
Small
46
Side 57
47
Slide the Seat Pin (45) through the Seat Carriage
(12) and an adjustment hole in the Bench Frame
(5).
47
46
47
47 57
Large Side
14
15
14. Press two 25mm Square Inner Caps (54) into the
indicated ends of the Backrest Frame (15). Press
the Backrest Cap (16) onto the other end of the
Backrest Frame. Attach a Plastic Foot (53) to the
Backrest Frame with an M4 Washer (92), and an
M4 x 25mm Screw (56).
16
92
53
17
56
Attach a Guard Plate (17) to the inside of the
Backrest Frame (15) with two M4 x 10mm Screws
(96). Attach the other Guard Plate in the same
manner.
54
17
96
15
14
15. Orient the Backrest (14) as shown. Attach the
Backrest to the Backrest Frame (15) with four M6
x 38mm Screws (58) and four M6 Washers (77).
15
77
58
77
58
9