Transcript
Setup Instructions - JS-XS300 Set up your keyboard on a sturdy, lightweight stand, with the JS-XS300 keyboard stand. Easily adjustable to sitting or standing heights thanks to the large tightening knob, the X-style keyboard stand accommodates a variety of playing situations. The JS-XS300 folds flat for easy transport and storage. SETUP INSTRUCTIONS — JS-XS300 PARTS INCLUDED : STEP 1. Stand top A. (2)Bottom Support Arms A. Knob B.(1)Cross-bar B. C. (1)Allen Wrench, Attached to Cross-bar D. C. Belt D. (2)Top Support Arms E. (4)Screws E. Stand bottom 1. Open the cross-bars until they snap into a stable position. See picture for upright position reference. STEP 3. STEP 2. Shorter end Shorter end Shorter end Shorter end Belt Knob Belt Knob 2.Using the provided Allen wrench and screws, attach the long supports legs to the bottom of the stand. The shorter end of each support leg should be facing away from the attaching cross-bar center joint (see picture). 3.Attach the shorter support arms to the top of the stand. Again, the shorter end of the support arm should be facing out away from the attaching cross-bar center joint (see picture). STEP 4. 4.To adjust stand height, pull the spring-loaded knob until the pin clears the adjustment plate. Adjust legs until stand is at desired height, then release knob so that the pin snaps into place in one of the holes on the adjustment plate. Do not turn the knob - this can result in the loss of the spring. R. 1, 08/31/10, JAM-HT_JS-XS300 5836 Wright Drive • Loveland, CO 80538 • Phone. 1-800-525-5628 • Fax. 970.776.1941 • Web. w w w.ultimatesuppor t.com
