Download Technicolor - Thomson DTH720 User's Manual

Transcript
2_DTH720_en
22/06/04
11:25
Page 3
Connections and initial set up
The rear panel of your television set and your video player may be different from the ones illustrated here.
Television set
EN
4
United Kingdom
Ireland
5
Continental
Europe
3
Video recorder
220 - 240 V
50 Hz
2
DTH 720
1
Connecting: DVD player + TV set + VCR
If you are only connecting your player to your television set, only carry out the connections shown in stages 1
and 5. If no Scart-Peritel socket is available on the TV set consult your retailer. If you already have a VCR the
connections shown in stages 3 and 4 should, in most cases, already be in place.
Recommended Audio – Video connections
1. Connect a Scart-Peritel cable (not supplied) to the TV AUDIO VIDEO OUT (RGB)
output socket at the rear of your DVD player and to the AV1 input socket of your television
set (sometimes called AUX 1 or EXT 1).
2. Plug your VCR Scart-Peritel cable into the VCR/SAT/AUX/AUDIO/VIDEO IN socket on
your DVD player and into the TV socket on your VCR.
3. Plug the outside aerial or the network into the aerial in socket (IN
) on the VCR.
4. Use a coaxial cable to connect the aerial out socket on the VCR (OUT
) and the aerial in
socket (
) on your TV set.
5. Plug the mains plug of your player into a mains socket.
Note: for UK, please see safety information regarding the mains plug at the end of this user manual, in the
cover page.
Continue on page 9
3