Download Sharp PN-V602 Quick Guide

Connections
Multiple monitor connection
[Example]
Remote control sensor box
(Supplied with the PN-ZR01 (optional))
Second monitor
Secondary
(Expansion unit)
ID No.: 2
First monitor
Primary
(Main unit)
ID No.: 1
Third monitor
Secondary
(Expansion unit)
ID No.: 3
Fourth monitor
Secondary
(Expansion unit)
ID No.: 4
■ Connection with RS-232 cable
If you connect the monitor in a daisy chain using RS-232
cable, using the monitor buttons on the primary (main unit),
settings are copied to the secondary (expansion unit) and
operation from the primary can perform operation for all
monitors. Setting each ID No. in the monitor is required.
The first monitor will be set as primary (main unit) and the
second monitor and beyond will be secondaries (expansion
units).
Connect the RS-232C cables in order, starting with the first
monitor (primary monitor). If monitors are connected in a
different order they may not be operable.
First monitor: primary
Second monitor: secondary
* Always install the remote control sensor box on the primary
monitor.
■ Connection with video cable
May vary depending on the system being used.
If using the PC/AV DVI-D terminal, up to 5 monitors can be
connected in a daisy chain. (When the PN-ZB02 is attached)
Second monitor
First monitor
PC/AV DVI-D
input terminal
PC/AV DVI-D
output terminal
RS-232C
output terminal
RS-232C
input terminal
RS-232C
output terminal
PC/AV DVI-D
input terminal
RS-232 straight cable
(commercially available)
Third monitor: connects to secondary
RS-232C input terminal
Digital signal (DVI) cables
(commercially available)
To PC digital RGB output terminal
shows the
signal flow
E
6
Connect the third monitor and other monitors in the same
manner.
Up to 25 monitors can be connected. (Depending on the
length of the cable used and the surrounding environment.)
ID Number is set with the primary monitor’s buttons. If you set
AUTO ASSIGN ID No., located in the menu of the monitor to
ON, the ID No. will be automatically assigned in order from the
primary.