Download Polycom Cell Phone 8002 User's Manual

Programming the SIP Handset Features
# press events. Normally you want this to be disabled for Asterisk but it
# depends on your configuration and what you want to be able to do.
# The default is disable
#PROXY1_KEYPRESS_2833 = disable
# PROXY1_KEYPRESS_INFO controls generation of SIP INFO requests to the SIP
# server for keypress events. Normally you want this to be enabled.
# The default is enable
#PROXY1_KEYPRESS_INFO = enable
# PROXYn_HOLD_IP0 controls setting of media stream IP destination to 0.0.0.0
# when a call is put on hold.
# PROXYn_HOLD_IP0 is not required for current versions of Asterisk.
# For older PBXs that require this, set this to enable
#PROXYn_HOLD_IP0 = enable
# PROXY1_PRACK enables ACK'd provisional responses to INVITE requests. The
# PRACK mechanism will be used if this switch is enabled and the Proxy server
# specifies support for the PRACK mechanism. PRACK is NOT SUPPORTED in
# current versions of Asterisk, but is to be supported on subsequent
# versions. PRACK should not be required on local area networks.
#PROXY1_PRACK = disable
#
#
#
#
#
////////////////////////
////// ABOVE this line should probably be in the sip_allusers.cfg file
////// with items uncommented in this file only for overriding a setting
////// for a particular user.
////////////////////////
# Authentication credentials
# (Normally not stored in this file for security reasons)
# AUTH = username; password
AUTH = 3001; 3001
# Line definitions
# Each definition should have LINEn, LINEn_PROXY and LINEn_CALLID
# LINEn is the dial number
# LINEn_PROXY is the PROXYn server this line should register with, typically
# defined in sip_allusers.cfg.
# LINEn_CALLID is shown on the standby display of 8020/8030 phones but not
# 8002 or e/h340/i640 phones. The Asterisk Server converts the callID
# information to alternative forms defined in the Asterisk configuration
# files for display at the far end of a phone call.
# Up to 5 line definitions can be made for each user
# Line definitions do not necessarily have to have different extensions
LINE1
= 3001
LINE1_PROXY
= 1
LINE1_CALLID = Mouse, Mickey
# Two lines may map to the same extension to allow second incomming calls.
LINE2
= 3001
LINE2_PROXY
= 1
PN: 1725-36034-001_C.doc
55