Download Miele KWT 1601 Vi Specification Sheet
Transcript
Product and Cut-out Dimensions KWT1611Vi / KWT1601Vi 84" 25" m in. 4" 23 3/ 24" EPTS ACC M T I N U STO A CU RAME NT F FRO O 83 1/2" - 85 3/8" 24" E Location Codes E - 5 foot - 120 Volt - 15 Amp 3-wire molded plug power supply connects lower left rear. O - Standard NEMA 5-15 Outlet - locate less than 9" above finished floor 4 1/8 " 6 5/8" - 8 1/2" 1 1/4 " 2" - 8 3/8" 9 1/2 " Notes • All Installations must be done in accordance with local codes • Sides of adjoining cabinets should be filled (flush to frame) to insure proper fit and finish NOTE: Drawing is not to scale. SPECIFICATION SHEETS 011208 Product and Cut-out Dimensions KWT1611Vi / KWT1601Vi Glass dimensions Hinge Hinge 1/2" - 2 3/8" 44 1/2" 65" 19" Centerline Notes • Centerpoint is 45 1/2" with typical 84" installation NOTE: Drawing is not to scale. SPECIFICATION SHEETS 011208 Front Panel Information Fully Integrated Model Custom Panel Installations These units do not come equipped with a front panel. They are designed to accept a custom door panel supplied by the cabinet maker. Miele has a unique panel integration system which allows the panels to align with the surrounding cabinets. Panel size is determined in the following manner: Width: 23 3/4" in all cases Thickness: Minimum 3/4" outside frame 5 7/8" Minimum Panel Height = HOC - TKH HOC = Total height of cabinet or side panel TKH = Toe-kick height HOC Panel Height Height: Determined using the following calculation: Note: Finish back side of panels to insure appearance Panel may extend above unit. This is not considered in height calculation Maximum hinge capacity: 200 Pounds Maximum panel weight: 128 Pounds 2 1/2 - 3 1/4" Both Sides 10 1/8" Minimum TKH Panel Notes If the adjoining cabinets are taller than the height of machine (HOM) - the front panel may be extended accordingly. Simply maintain the toekick height and extend the panel the needed distance. Adjoining cabinet Extended Panel Machine NOTE: Drawing is not to scale. SPECIFICATION SHEETS 011208 Front Panel Information Hinging Details 90° Door 115° Door Thickness options Thickness options 0-1/8" 0-1/8" 0-3/4" 1" 1-1/4" 1-1/2" 1-3/4" 0-3/4" 1" 1-1/4" 1-1/2" 1-3/4" 2" Cabinet Front Cabinet Front 1" Fro nt P ane l 0-3/4" 1-1/2" 1-1/4" 1" 1-1/4" Front Panel 0-3/4" 1-1/2" Door Swing Door Swing 11 3/4" MAX 26 11/16" 7/16" NOTE: Additional space needed depending on thickness of front panels and handle used NOTE: Additional space needed depending on thickness of front panels and handle used NOTE: Drawing is not to scale. SPECIFICATION SHEETS 011208