Transcript
Assembly Instructions Wrench x1 3 Place finger over Hole G (to keep Pin B from falling out) and turn leg upside down. Bench x1 Leg x4 A x4 B x4 C x4 D x4 E x4 Put Screw A through Hole F, lining up the hole in 1 Screw A with Hole G. 2 Leg G Bench 4 With finger still covering Hole G, slide leg into corner of bench, pushing Screw A through hole in bracket. 5 lace Flat Washer C and then Tension Washer D P over Screw A, and then tighten Nut E with included wrench. Drop Pin B (point side down) into Hole G. Leg A B Bench G A C F D E Leg 6 Repeat Steps 1-5 to attach remaining three legs.
