Download Kohler K-723-H2 User's Manual
Transcript
MEMOIRS® Features • • • • • • • 5’ BATH WHIRLPOOL K-723-H2 Cast iron with Safeguard® finish Left or right drain ADA compliant when installed per Section 607 of the Act Less all trim Variable-speed pump with 1.5 kW heater, back-lit user keypad, and remote control 6 FlexjetsTM 60″ (1524 mm) x 33-3/4″ (857 mm) x 17-7/16″ (443 mm) ALSO K-724-H2 Codes/Standards Applicable Specified model meets or exceeds the following: • • • • • • • ASME A112.19.1/CSA B45.2 ASME A112.19.7 CSA B45.10 CSA C22.2 No 218.2 UL 1795 ADA ICC/ANSI A117.1 Colors/Finishes • 0: White • Other: Refer to Price Book for additional colors/finishes Accessories • CP: Polished Chrome • PB: Vibrant® Polished Brass • Other: Refer to Price Book for additional colors/finishes Specified Model Model K-723-H2 K-724-H2 Description 5’ bath whirlpool – left drain 5’ bath whirlpool – right drain Colors/Finishes ❑0 ❑ Other_____ ❑0 ❑ Other_____ Required Accessories K-9696 Jet trim kit ❑ CP ❑ PB ❑ Other_____ Recommended Accessories K-7161-AF Clearflo pop-up bath drain ❑ CP ❑ PB ❑ Other_____ Optional Accessories K-1491 Pillow K-1601 Footstop ❑0 ❑0 ❑ Other_____ ❑ Other_____ Product Specification The bath whirlpool shall be 60″ (1524 mm) in length, 33-3/4″ (857 mm) in width, and 17-7/16″ (443 mm) in height. Bath whirlpool shall be made of cast iron with Safeguard finish. Bath whirlpool shall have 6 Flexjets, a variable speed pump with 1.5 kW heater, and back-lit user control. Bath whirlpool shall be less all trim. Bath whirlpool shall be ADA compliant when installed per Section 607 of the Act. Bath whirlpool shall be Kohler Model K-_______-_______-_______. Page 1 of 2 1019707-4-E USA/Canada: 1-800-4KOHLER (1-800-456-4537) www.kohler.com MEMOIRS® Technical Information Required Electrical Service Fixture*: Bathing well: Basin area, bottom 45” (1143 mm) x 23” (584 mm) Basin area, top 54” (1372 mm) x 25” (635 mm) Weight 390 lbs (176.9 kg) To overflow: Water depth 11-5/8” (295 mm) Capacity 52 gal (196.8 L) * Approximate measurements for comparison only. Dedicated circuit required, protected with Class A Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD): Pump/control 208-240 V, 20 A, 50/60 Hz Installation Notes NOTE: Pump protrusion beyond rim. Install this product according to the installation guide. Floor support under whirlpool must provide for a minimum of 61 lbs/square foot (295 kg/square meter) loading. Pump kW V A* 1.5 240 11 * Approximate measurements for comparison only. Minimum access panel (required): Pump/control 30″ (762 mm) W x 15″ (381 mm) H 1" (25 mm) No change in measurements if connected with drain illustrated. (K-7161-AF or K-7161M-AF) Pump Protrudes Beyond Rim 16" (406 mm) 32" (813 mm) 1-1/2" (38 mm) 1-13/16" (46 mm) 8-1/2" (216 mm) Pump/Control Access 60" (1524 mm) 3-1/4" (83 mm) 3" (76 mm) 33-3/4" (857 mm) 17-7/16" (443 mm) 2-7/8" (73 mm) Product Diagram MEMOIRS® 5’ BATH WHIRLPOOL Page 2 of 2 1019707-4-E 1/8" (3 mm) 1-1/2" OD