Download Keating Of Chicago Instant Recovery 004341 User's Manual
Transcript
SERVICE INSTRUCTIONS www.keatingofchicago.com 1-800-KEATING MOUNTING INSTRUCTIONS FOR REPLACING HI-LIMIT CONTROL #004341 (BACK MOUNT) WITH #034357 (BOTTOM MOUNT) FOR IFM & GAS FRYERS & PASTA COOKERS 1. Line up template with reset button clearance hole in bottom of control panel back. Hold in place & mark hole centers. 2. Drill (2) Ø0.201 (#7) holes. 3. Drill (1) 0.413 hole. 4. Install new hi-limit control using (2) #8-32 x 1/4” screws (part #017744). FRONT VIEW OF FRYER OR PASTA COOKER WITH CONTROL PANEL REMOVED TEMPLATE Align the center hole of the template below with the existing reset button hole in the control panel back. Drill the 3 needed holes. See View A-A. CONTROL PANEL BACK REF. LINE UP TEMPLATE ON EXISTING HOLE AS SHOWN. DRILL (2) .201 #7 HOLES AND (1) .413 "Z" 0.201 DRILL (2) #7 LINE UP WITH EXISTING HOLE WHEN REPLACING 004341 WITH 034357 0.413 "Z" SIZE PART #004341 Remove wires as shown and replace on 034357 as shown e wires as shown place on 034357 as shown VIEW A-A (BOTTOM VIEW) HI-LIMIT RESET BUTTON If the Hi-limit has been activated, press the red button to reset after the oil cools. PART #034357 The red button is located under the control panel. PART #031112 REV 2 DATE: 12/13/06 5/98 HiLmtCntrl SERVICE INSTRUCTIONS www.keatingofchicago.com 1-800-KEATING MOUNTING INSTRUCTIONS FOR REPLACING HI-LIMIT CONTROL #025584 (BACK MOUNT) WITH #034357 (BOTTOM MOUNT) FOR IFM & GAS FRYERS & PASTA COOKERS 1. Line up template with reset button clearance hole in bottom of control panel back. Hold in place & mark hole centers. 2. Drill (2) Ø0.201 (#7) holes. 3. Drill (1) 0.413 hole. 4. Install new hi-limit control using (2) #8-32 x 1/4” screws (part #017744). FRONT VIEW OF FRYER OR PASTA COOKER WITH CONTROL PANEL REMOVED TEMPLATE Align the center hole of the template below with the existing reset button hole in the control panel back. Drill the 3 needed holes. See View A-A. CONTROL PANEL BACK REF. LINE UP TEMPLATE ON EXISTING HOLE AS SHOWN. DRILL (2) .201 #7 HOLES AND (1) .413 "Z" 0.201 DRILL (2) #7 WHEN REPLACING 004341 WITH 034357 WHEN REPLACING 025584 WITH 034357 0.413 "Z" SIZE PART #004341 PART #025584 Remove wires as shown and replace on 034357 as shown PART #034357 LINE UP WITH EXISTING HOLE Remove wires as shown VIEW A-A and replace on 034357 (BOTTOM as shown VIEW) HI-LIMIT RESET BUTTON If the Hi-limit has been activated, press the red button to reset after the oil cools. PART #034357 The red button is located under the control panel. PART #031112 REV 2 DATE: 12/13/06 5/98 HiLmtCntrl