Download JVC HR-DVS3EU User's Manual

Filename [DVS3EU_1a-EN.fm]
Masterpage:Right
DVS3EU_1a-EN.fm Page 17 Monday, October 8, 2001 2:44 PM
EN
SAT CONTROL SET
Satellite Receiver
Control Setting
Satellite receiver
17
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the SHOWVIEW timer
programming (墌 pg. 36) or Express timer programming
(墌 pg. 38) starts, the recorder sets its input mode to “L-2”
and automatically switches the satellite receiver’s
channels using the provided Satellite Controller.
Installing Satellite Controller
A Situate the Satellite Controller.
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B Attach the Satellite Controller.
Satellite Controller
(suggested locations)
Your recorder
Transmitter
Satellite Controller
(provided)
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
C Make connections.
Be sure to connect the recorder’s AV2 (L-2) IN/DECODER
connector to the satellite receiver’s 21-pin SCART
connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
Satellite receiver
D Connect the Satellite Controller to recorder.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
21-pin SCART cable
(provided)
SAT CONTROL
Back of recorder
AV2 (L-2) IN/DECODER
Page 17
October 8, 2001 2:37 pm