Download GE mn-35002 Technical Specifications
Transcript
Actuator Mounting Guide 3 CAMFLEX II VALVES (Mounted On Horizontal Pipeline) 5 - 3 . 5 2 0 Actuator Position in Relation to Valve Body Numbering System : 1 to 8 Plug Position F.T.C Plug Position F.T.C II LEX CAMF ilan sone Ma F.T.O 4 Masoneilan 2 F.T.O Plug Position F.T.O ose n -Cwl Directio o T w- Flo Flommended o c e R pen o-O T w Flo 8 Masoneilan CAMFLEX II F.T.C Plug Position CAMFLEX II EN -OP O -T AIR Plug Position F.T.O II LEX CAMF ilan sone Ma 6 F.T.C Plug Position F.T.C F.T.C 1 II LEX CAMF ilan sone Ma 3 E OS L C -TO AIR e Masoneilan CAMFLEX II s Clo ow-T Flo en -OpDirection o T w- low Flomended F om Rec Plug Position F.T.O II LEX CAMF ilan sone Ma Plug Position F.T.O 5 7 F.T.C Masoneilan F.T.C F.T.O CAMFLEX II F.T.O Notes: NOTES : 1. It is recommended2.that the actuator always be mounted as shown above. For other positions, consult your local sales office. Standard actuator mounting positions are shaded : 2. Installation is assumed to be in the horizontal pipeline for orientation of the airset and other accessories unless specified on the order. 2. Plug positions are shown in the initial position without air on actuator. 3. Action and orientation are field reversible without additional parts. 3. The actuator must be always mounted above the pipeline. 4. Operating efficiencies may vary depending on valve configuration. 5. The above schematic does not reflect every possible body/actuator orientation, but should serve as an effective guide. 4 | GE Oil & Gas