Download GE JX2201NSS User's Manual
Transcript
PSB1201NSS GE Profile Advantium® 120 Volt - 30" Wall Oven Advantium Wall Oven Dimensions (in inches)and Advantium wall oven/GE Profile cooking tower dimensions and cabinet installation information (in inches) Cabinet Installation (in inches) Note: 2" minimum between cutouts when installed above warming drawer or single wall oven. 4-3/16 Cabinet width A= Allow 1" overlap of oven over bottom edge of cutout, and allow 1-1/4" overlap at top edge of cutout. B= Allow 11/16"-3/4" for overlap of oven over side edges of cutout. Installation Information: Before installing, consult installation instructions packed with product for current dimensional data. 23-1/2" Cutout depth Note: Cabinets installed adjacent to wall ovens must have an adhesion spec of at least 194° F temperature rating. Note: PSB1200/1 series Advantium can be 19-1/32" installed below GE/GE Profile non-downdraft gas and electric cooktops. It CANNOT be installed below induction or Monogram (2GU3841385) gas cooktops. Junction box location (240-volt models only) A 4-3/16" H D 2-1/2" MIN between cutouts recommended—2" MIN required Excluding Handle 21-1/2" Excluding Handle W A Conduit (48-1/2" long) 29-25/32" 30" Note: PSB1200/1 series Advantium oven comes with two lower trim pieces. One is for use above 36-inch height installations and one is for use below 36inch installations. Use of the accessory drawer will replace the bottom trim piece for applicable installations. Please see installation instructions for full details. Junction box location A B B Construct Solid Bottom MIN 3/8" Plywood Supported by 2 x 4 or 1 x 2 Runners, all Four Sides. (Must Support 150 lbs. for Advantium) (Must Support 200 lbs. for Wall Oven) Conduit (46" long) 17-1/2" Cutout height Construct Solid Bottom Min. Plywood Advantium Wall 3/8" Oven Dimensions Supported by Cabinet Installation (in1 xinches) 2 x 4 or 2 Runners, all Four Sides. (Must Support 5" min.from 150 lbs.) floor 1" min. above toekick (in inches)and 9-1/4" cutout height 28-1/2" cutout width MIN between cutouts A= Allow 1" overlap of oven over bottom edge of2"cutout, and allow 1-1/4" overlap at top edge of cutout. B= Allow 11/16"-3/4" for overlap of oven over side edges of cutout. 23-1/2" 1" Min. above toekick or adjust Cutout depth to oven installation height 4-3/16" Note: Cabinets installed adjacent to wall ovens must have an adhesion spec of at least 194° F temperature rating. 21-1/2" Excluding Handle Junction box location A CL adv_240_120_cooktower_dia.eps B 2 x 4’s or equivalent solid floor 19-1/32" Cabinet Width Conduit W (48-1/2"H Width long) Height (inches) For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. B Suitable bracing to support runners 21-5/8" over centerline of cabinet PSB1200/1 without accessory drawer 30 PSB1200/1 with accessory drawer 30 D 17-1/2" Cutout heightX Depth Cutout (excluding handle) Width 29-25/32 19-1/8 21-3/4 29-25/32 22-1/4 21-3/4 29-25/32" *For existing cutouts a maximum width of 28-1/2" is acceptable 30" Construct Solid Z Y Min. Cutout Bottom Cutout 3/8" Plywood Depth Height Supported by(minimum) 2 x 4 or 1 x 2 Runners, 25-1/8 17-1/2 all 23-1/2 Four Sides. 25-1/4 to (Must Support 21 23-1/2 28-1/2* 5" min.from 150 lbs.) floor 1" min. above toekick Listed by Underwriters Laboratories (Must support 130 lbs.) Specification Created 11/08 cooking_tower_solid_floor.eps 240446 PSB1201NSS GE Profile Advantium® 120 Volt - 30" Wall Oven Preparation with an Accessory Drawer Prepare the opening The Advantium PSB1200/1 series can be installed in combination with other GE/Monogram appliances. Always follow each product's Installation Instructions to compete the installation. Single Oven Installation: Order a 30" wide single oven cabinet or cut the opening in a wall to the dimensions shown. 30” 23-1/2” * For existing cutouts, a maximum width of 28-1/2" is acceptable. If 25-1/4” the opening is slightly wider, secure Min. a furring strip on each side of the cutout for securing the oven. 21” • Allow 3/4" to 2-1/8" case trim overlap Construct on the sides and 7/8" overlap on the Base bottom of the opening for all models. Min. 3/8” Plywood 5” min. The amount of overlap on the sides Supported from floor by 2x4 or 2x2 depends on the actual cutout width. 1” min. Runners all above Four Sides Allow 1-1/4" case trim overlap on the toekick top for models PSB1200 and PSB1201 and for models ZSC1201 and ZSC1202. • Oven overlaps will conceal cut edges on all sides of the opening. Note: PSB1200/1 series Advantium can be installed below GE/GE Profile non-downdraft gas and electric cooktops. It CANNOT be installed below induction or Monogram (2GU3841385) gas cooktops. Note: PSB1200/1 series Advantium oven comes with two lower trim pieces. One is for use above 36-inch height installations and one is for use below 36-inch installations. Use of the accessory drawer will replace the bottom trim piece for applicable installations. Please see installation instructions for full details. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Prepare the opening (cont.) When installed over a single oven or a warming drawer, allow at least 2" between the two openings. This separation will provide clearance for bottom overlap of the Advantium and the other appliance overlaps. Construct a solid oven floor of 3/8" min. thick plywood supported by 2 x 4 or 2 x 2 runners on all sides. • the support must be level and rigidly mounted, flush with the bottom edge of the cutout. Installation over a GE/Monogram Warming Drawer: 23-1/2” 30” 25-1/4” Min. 21” 5” min. from floor 1” min. above toekick Construct Solid Bottom Min. 3/8” Plywood Supported by 2x4 or 2x2 Runners all Four Sides 2” Min. (3” recommended) Per warming drawer requirement Installation over a GE/Monogram Oven and Warming Drawer: Warming Drawer: 30” 23-1/2” 25-1/4” Min. 21” Construct Solid Bottom Min. 3/8” Plywood Supported by 2x4 or 2x2 Runners all Four Sides 2” Min. (3” recommended) Per Oven Requirement 5” min. from floor 1” min. above toekick 2” Min. Per warming drawer requirement Note: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. Caution: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven and 30pound drawer, plus additional oven loads of up to 50 pounds or a total weight of 160 pounds. Note: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. Listed by Underwriters Laboratories Specification Created 11/08 240446 PSB1201NSS GE Profile Advantium® 120 Volt - 30" Wall Oven Features and Benefits •Speedcook Technology - Cooks up to 4 times faster than a conventional oven N TO SELECT TUR MICROWAVE OVEN CONV SPEED COOK BAKE BROIL COOK EXPRESS FAVORITE CUSTOM WARM PROOF DEFROST REHEAT TIMER SPEED COOK START PAUSE RECIPES CLEAR OFF BACK HELP POWER TEMP OPTIONS PRES S TO ENTER •4 Ovens in 1 to Meet Your Cooking Needs - Speedcook, True European Convection, Warming/Proofing, Sensor Microwave •Under-the-counter installation - provides installation flexibility to accommodate a variety of kitchen designs •Saves valuable time by eliminating preheating •16" Turntable - Allows complete rotation of a 9" x 13" casserole dish •Preprogrammed Recipes - Provide quick and easy programming of over 175 speedcook food selections •Multi-Level Cooking - Removable pedestal rack allows cooking of multiple dishes at once • Model PSB1201NSS - Stainless steel PSB1201NSS Note: PSB1200/1 series Advantium can be installed below GE/GE Profile non-downdraft gas and electric cooktops. It CANNOT be installed below induction or Monogram (2GU3841385) gas cooktops. Accessories: For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Optional Storage Drawer Available (JX2201NSS) JX2201NSS Specification Created 11/08 240446