Transcript
RFF 052 and RFF 054 False Plates for 1-inch Products Installation Guide The Extron® False Plates for 1-inch Products increase the face height of 1-inch tall, quarter rack width (RFF 054) or half rack width (RFF 052) products to full single rack unit height (1U), aiding airflow management and aesthetics. Install plates as follows: 1. Clean the 1-inch tall Extron device to be rack mounted of any dust or debris. 2. Remove the protective film from the adhesive tape on the RFF 052 or RFF 054. 3. Align the plate on the top of the device so that the adhesive faces the device and the raised side runs flush with the front panel of the device. 4. Firmly press the plate onto the device. 5. Install the 1-inch tall device to the rack shelf. 2 Extron USA - West Headquarters +800.633.9876 Inside USA/Canada Only +1.714.491.1500 +1.714.491.1517 FAX 3 5 4 Extron USA - East Extron Europe Extron Asia +800.633.9876 Inside USA/Canada Only +800.3987.6673 Inside Europe Only +800.7339.8766 Inside Asia Only +1.919.863.1794 +1.919.863.1797 FAX +31.33.453.4040 +31.33.453.4050 FAX +65.6383.4400 +65.6383.4664 FAX Extron Japan Extron China Extron Middle East +400.883.1568 Inside China Only +81.3.3511.7655 +81.3.3511.7656 FAX +86.21.3760.1568 +86.21.3760.1566 FAX © 2011 Extron® Electronics. All rights reserved. www.extron.com +971.4.2991800 +971.4.2991880 FAX 68-2160-01 Rev. A 07 11
