Download Desa VP325E(B) User's Manual

INSTALLATION
12
Ember and Pan Material Placement
Log Placement for P324E/VP324E Models
INSTALLATION
Continued
EMBER AND PAN MATERIAL PLACEMENT
LOG PLACEMENT FOR P324E/VP324E MODELS
1.
1.
2.
3.
4.
Open the bag(s) of vermiculite and fill the entire burner pan
until the burner tube is completely covered (see Figure 20).
Smooth the pan material just even with edges of the burner pan.
Remove the ember material from the bag and flatten small
amounts into quarter size pieces and lay on top of the surface
of the pan material (see Figure 21).
Place just enough to cover the entire surface and leave about a
1/2 inch gap under the lower grate members to allow air to
flow (see Figure 22).
Vermiculite
(Pan Material)
Grate
Burner Pan
2.
3.
4.
Place front (log 1) onto front of grate sliding log all the way
forward against grate fingers (see Figure 23).
Insert pegs on bottom of rear log (log 2) into holes in rear of
grate (see Figure 23).
Place log 3 into notches on left side of logs 1 and 2 (see Figure 24).
Place log 4 into notches on right side of logs 1 and 2 (see Figure 24).
To enhance the look of the hearth you may optionally place the lava
rock provided around the front and sides of the burner.
NOTICE: Do not put lava rock inside the burner pan or
around the air mixer fitting. Placing lava rock inside the
burner pan or blocking the openings of the propane/LP
air-mixer could cause performance problems.
Log 1
Log 2
Figure 20 - Fill Entire Burner Pan with Vermiculite (P325E/
VP325E Model Shown)
Ember
Material Vermiculite
Burner Pan
Grate
(Pan Material)
Figure 23 - Installing Logs 1 and 2
Figure 21 - Ember Material on Surface of Pan Material
(Vermiculite) (P325E/VP325E Model Shown)
Pan and Ember
Grate
Material
Log 4
0.5"
Log 3
0.5"
Burner Pan
Figure 22 - Pan and Ember Material Clearances (P325E/VP325E
Model Shown)
Figure 24 - Installing Logs 3 and 4
For more information, visit www.desatech.com
108794-01D