Download Delta Electronics VFD-PU06 User's Manual

2007-07-19
5011615002-U6E2
VFD-PU06 Digital Keypad Instruction Sheet
X Description of the Digital keypad VFD-PU06
LED Display
Indicates frequency, voltage, current, user
defined units, read, and save, etc.
Frequency Command
Status indicator
F
H
U
Output Frequency
Status indicator
Model Number
VFD-PU06
User Defined Units
Status Display
Status indicator
Display the driver's current status.
EXT PU
JOG
By pressing JOG key,
Jog frequency operation.
MODE
UP and DOWN Key
Change between different display mode.
PU
JOG
Set the parameter number
and changes the numerical
data, such as Master Frequency.
Left Key
Right key
Move cursor to the left.
Move the cursor to the right
FWD/REV Key
Select FWD/REV operation.
RUN
STOP
RESET
STOP/RESET
Stops AC drive operation and reset the drive
after fault occurred.
RUN Key
Start AC drive operation.
Y
Explanation of Display Message
Display Message
Descriptions
The AC motor drive Master Frequency Command.
The Actual Operation Frequency present at terminals U, V, and W.
The custom unit (u)
The output current present at terminals U, V, and W.
Press
to change the mode to READ. Press PROG/DATA for about 2
sec or until it’s flashing, read the parameters of AC drive to the digital keypad
PU06. It can read 4 groups of parameters to PU06. (read 0 - read 3)
Press
to change the mode to SAVE. Press PROG/DATA for about 2 sec
or until it’s flashing, then write the parameters from the digital keypad PU06 to
AC drive. If it has saved, it will show the type of AC motor drive.
The specified parameter setting.
The actual value stored in the specified parameter.
Display Message
Descriptions
External Fault
“End” displays for approximately 1 second if the entered input data have been
accepted. After a parameter value has been set, the new value is automatically
stored in memory. To modify an entry, use the
or
keys.
“Err” displays if the input is invalid.
Communication Error. Please check the AC motor drive user manual (Chapter
5, Group 9 Communication Parameter) for more details.
Z Operation Flow Chart
VFD-PU06 Operation Flow Chart
Or
XX
Press UP key to select
SAVE or READ.
Press PROG/DATA for
about 2 seconds or until
it is flashing, then save
parameters from PU06 to
AC drive or read parameters
from AC drive to PU06.
XX-XX
XXXXX
-ERRProgram
Error
-ENDProgram
Successful