Transcript
INSTALLATION INSTRUCTIONS JUNCTION BOX ASSEMBLY CEILING PLATE CMA-106 The Ceiling Plates are designed for ease of installation with any height of ceiling. By using any length of standard NPT 1½” pipe threaded both ends, you can extend the height capabilities to meet your needs. WARNING: IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY! When mounting Chief Manufacturing accessories, the structural system and mounting method MUST be capable of supporting 5 times the combined weight of the total installation. The maximum weight to be installed on the ceiling plate is 50 pounds (22.7 Kg). Unpack and check contents: (1) Ceiling Plate (2) #10 Fender Washer (2) #10-32 Socket Screw (2) #10 Lock Washer (1) 1/8” Hex Key (1) #10-24 x 1/4” Socket Screw (1) 3/32” Hex Key 1. Securely install the Junction Box Assembly, per manufacturer instruction. (SEE WARNING ABOVE). 2. Using the #10-32 screws, fender washers, lock washers and hex key provided, install ceiling plate (SEE DIAGRAM BELOW). 3. Install 1 ½” NPT into fitting and secure using #10-24 x 1/4” set screw. 4. Follow the Ceiling Mount Instructions for mating components or mounts Not Included 10-24 x ¼” Setscrew ceiling plate Fender Washer Lock Washer #10-32 Socket Screw CHIEF MANUFACTURING INC. 1-800-582-6480 952-894-6280 FAX 952-894-6918 8401 EAGLE CREEK PARKWAY, STE. 700 SAVAGE, MINNESOTA 55378 USA 8803-000056 (Rev. C) 2004 Chief Manufacturing www.chiefmfg.com 01/05
