Transcript
INSTALLATION INSTRUCTIONS SMA-651 INSTALLATION ADAPTER KIT FOR SMART-LIFT 236 The SMA-651 installation adapter kit allows you to attach the Smart-Lift (model SL-236) to threaded rods or cables for suspended ceiling mounting applications. Unpack carton and check contents: (4) (4) (8) Bolt, hex head, 3/8 – 16 x 1” Nut, Nylock, 3/8-16 Washer (1) (1) Rear Adapter Front Adapter CAUTION!!! The overhead support must be capable of supporting five times the combined weight of the lift and all equipment. If it cannot, it MUST be reinforced. INSTALLATION INSTRUCTIONS 1. Make sure Smart-Lift is fully closed. Remove bottom panel of Smart-Lift. 2. Insert four 3/18-16 x 1” bolts and washers in holes in top of Smart-Lift (see Figure). 3. Secure two hanging rod adapters to the Smart-Lift using four Nylock nuts and washers as shown in the Figure below. 4. Reinstall bottom panel. 5. See Smart-Lift Installation Instructions. CHIEF MANUFACTURING INC. 1-800-582-6480 952-894-6280 FAX 952-894-6918 8401 EAGLE CREEK PARKWAY, STE. 700 SAVAGE, MINNESOTA 55378 USA 8820-000005 (Rev. A) 2005 Chief Manufacturing www.chiefmfg.com 4/05
