Download Avaya Configuring IPX Services User's Manual

Configuring IPX Services
Parameter: Pace
Path:
Default:
Range:
Function:
Configuration Manager > Protocols > IPX > Interfaces > RIP
18
0 to 1000
Specifies the maximum pace (in packets per second) at which RIP packets can be
sent on this circuit. A value of zero means that there is no limit on the pace.
Instructions: Accept the default or specify an integer value up to 1000.
MIB Object ID: 1.3.6.1.4.1.18.3.5.5.32.1.7
Parameter: Update Interval (sec)
Path:
Default:
Range:
Function:
Configuration Manager > Protocols > IPX > Interfaces > RIP
60
0 to 2678400
Adjusts the frequency of RIP update packet transmissions, in seconds, for this
circuit.
Instructions: The higher the number you enter, the less frequent the transmissions. If you enter
zero, no periodic RIP updates are sent out over the IPX interface to the router.
However, RIP immediate (one-time) update packets still propagate through the
network, in compliance with Novell standards.
MIB Object ID: 1.3.6.1.4.1.18.3.5.5.32.1.8
Parameter: Age Multiplier
Path:
Default:
Range:
Function:
Configuration Manager > Protocols > IPX > Interfaces > RIP
3 (update interval increments)
1 to 6 (increments)
Specifies the holding multiplier as the number of update intervals for information
received in RIP periodic updates.
Instructions: Accept the default value or specify a value in the range 1 to 6. Increasing this
value can cause routes to take longer to age out. Decreasing it could cause the
router to age routes prematurely, if routing updates are missed. The combination
of the update interval and age multiplier should be the same for all systems on a
network segment.
MIB Object ID: 1.3.6.1.4.1.18.3.5.5.32.1.9
A-36
114051 Rev. A