Transcript
COLONY™ 24" PEDESTAL SINK VITREOUS CHINA COLONY™ 24" PEDESTAL SINK • Vitreous china lavatory and pedestal • Front overflow • Fitting ledge with generous shelf area • Supplied with mounting kit Shown with 2385.060 Reliant faucet (not included) ❏ 0113.411 Faucet holes on 4" (102mm) centers (Illustrated) ❏ 0113.811 Faucet holes on 8" (203mm) centers Nominal Dimensions: 23-3/4" x 20" x 35-1/4" (603 x 508 x 895mm) Separate Components: ❏ 0113.404 Pedestal top 4" (102mm) centers ❏ 0113.808 Pedestal top 8" (203mm) centers ❏ 731100-400 Pedestal only Bowl sizes: 18-1/2" (470mm) wide 12-1/2" (318mm) front to back 5-1/2" (127mm) deep Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures 4" (102mm) FINISHED WALL 3-3/4" (95mm) 5-1/2" (140mm) 8" (203mm) PEDESTAL ANCHORING SCREW HOLES 3/8" (10mm) DIA. 20" (508mm) 1-3/4" DIA. STD. DRAIN OUTLET PEDESTAL BASE 23-3/4" (603mm) 3/8" (10mm) DIA. ANCHOR SCREW HOLES ON 16" (406mm) CTRS 8" (203mm) To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Faucet: ❏ Faucet Finish: ❏ Supplies: ❏ 1-1/4" Trap: 20-3/4" (527mm) 5" (127mm) REF. PEDESTAL/WALL CLEARANCE 16" (406mm) 1-1/4" (32mm) S9 WALL-MT HANGER 4-1/4" (108mm) DRAIN CHASE 5-1/2" (140mm) 5/16" (8mm) X 1-1/16" (27mm) ANCHOR SCREW HANGER MTG HOLES (2) ON 4-1/2" (114mm) CTRS *21" (533mm) FINISHED FLOOR 8" (203mm) SUPPLIES AS REQUIRED 1-1/4" O.D. WASTE 1-1/4" O.D. TAILPIECE 35-1/4" (895mm) 28-1/4" (718mm) *23" (584mm) OPEN TO FLOOR ANCHOR SCREW HOLES (2) 3/8" (10mm) DIA. ON 4-3/4" (121mm) CTRS 8" (203mm) NOTES: DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE *SUGGESTED. ▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED. ■ SUITABLE FOR REINFORCEMENT ONLY, ACTUAL DIMENSIONS MUST BE TAKEN FROM FIXTURE. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. J14 Revised 2/08
