Transcript
BELMOR™ 5' TUB ENAMELED CAST IRON BARRIER FREE BELMOR™ 5' CAST IRON TUB ❏ 2697.102 Right hand outlet ❏2697.202 Left hand outlet Product Features: •Enameled cast iron construction •One-piece bath •Integral apron •Comfortable lumbar support •End drain outlet •Full slip-resistant pattern Nominal Dimensions: 60" x 30" x 14" (1524 x 762 x 356mm) 229 x 305mm 9" X 12" HOLE IN SUB FLOOR FOR BELOW FLOOR ROUGH 38mm 1-1/2" Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.1 for Cast Iron Plumbing Fixtures • ASTM F-462 for Slip-resistant Bathing Facilities • CAN / CSA B45 Series To Be Specified: ❏ Color: ❏ Bath Faucet*: ❏ Faucet Finish: ❏ Drain: 1583.470 FINISHED WALL 206mm 8-1/2" STD. 1-1/2 DRAIN OUTLET FINISHED WALL FINISHED WALL 76mm 3" 6mm 1/4" 13mm 1/2" 1524mm 60" 64mm 2-1/2" DIA. 356mm FINISHED 14" WALL * See faucet section for additional models available SUPPORT FEET ROUGH FLOOR 762mm 30" 381mm 15" NOTES: RIGHT HAND OUTLET SHOWN, RIGHT HAND REVERSE DIMENSIONS (2697.102). PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS. FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY. ■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BATH. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.1. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet. GENERAL SPECIFICATIONS FOR 2697 BATHING POOL 60 x 30 x 14 In. (1524 x 762 x 356mm) INSTALLED SIZE 430 Lbs. (195 Kg.) WEIGHT 715 Lbs. (320 Kg.) WEIGHT w/WATER 34 Gal. (128 L) GAL. TO OVERFLOW 42 x 18 In. (1066 x 457mm) BATHING WELL AT SUMP 24 x 55 In. (610 x 1397mm) BATHING WELL AT RIM 10 In. (254mm) WATER DEPTH TO OVERFLOW 60 Lbs./Sq.Ft. (293 Kgs./Sq.m) FLOOR LOADING 2 12.5 (PROJECTED AREA FT ) MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES-CHECK LOCAL CODES. INSTALL WITH SEAT AT HEAD END. © 2008 AS America Inc. H160 Revised 2/08