Download Technoline Weather Station

Note:
When the 433MHz signal is received correctly, do not re-open the battery cover of either the transmitter or Weather
Station, as the batteries may spring free from the contacts and force a false reset. Should this happen accidentally
then reset all units (see Setting up above) otherwise transmission problems may occur.
The transmission range is about 25 m from the transmitter to the Weather Station (in open space). However, this
depends on the surrounding environment and interference levels. If no reception is possible despite the
observation of these factors, all system units have to be reset (see Setting up).
POSITIONING THE WEATHER STATION:
The Weather Station comes attached with removable table stand, which provides the option of
table standing or wall mounting the unit. Before wall mounting, please check that the outdoor
temperature and humidity values can be received from the desired locations. To wall mount:
1.
Fix a screw (not supplied) into the desired wall, leaving the head extended out the by
about 5mm.
2.
Remove the stand from the Weather Station by pulling it way from the base and hang it
onto the screw. Remember to ensure that it locks into place before releasing.
POSITIONING THE THERMO-HYGRO OUTDOOR TRANSMITTER
The Thermo-Hygro Outdoor Transmitter is supplied with a holder that may be attached
to a wall with the three screws supplied. Before securing the transmitter, ensure that the
433MHz signal is properly received. To attach to the wall, please follow the steps below:
1.
Mark the wall using a pen through the holes in the holder to obtain the exact
drilling position.
2.
Drill holes in the wall at the points marked.
3.
Screw holder onto wall.
50