Transcript
Technical Specifications SPACEDEC DONUT 42 & 50 & DONUT COMBO Maximum Load: 11.5 kgs (25lbs) 90mm (3 9/16”) Donut 50 90mm (3 9/16”) Donut 42 +/- 40º Rotation +/- 40º Rotation 42mm (1 5/8”) 51mm (2”) 169mm (6 5/8”) 169mm (6 5/8”) +/- 40º Rotation +/- 40º Rotation 124mm (4 7/8”) 124mm (4 7/8”) * This product is VESA compliant and suits both 75mm (3”) and 100mm (4”) LCD display mounting hole patterns. NOTE: Add 25mm (1”) for Quick Release Donut Combo IMPORTANT: Each of the Donut Bolts must be tightened evenly. Failure to do so will damage the Donut Clamp. Do not over-tighten as this may also result in damage. 9 8 100mm (4”) 75mm (3”) 75mm (3”) 100mm (4”) Note: Extension Clips are included to suit VESA 100mm x 100mm (4” x 4”) Mounting Hole Patterns. No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 01.02.08