Transcript
Memory Module Specification KVR133X64C3/512 512MB 64M x 64-Bit PC133 CL3 168-Pin DIMM Module DESCRIPTION: This document describes ValueRAM's 64M x 64-bit (512MB) CL3 SDRAM (Synchronous DRAM) PC133 DIMM module. The components on this module include sixteen 32M x 8-bit (8M x 8-bit x 4 Bank ) PC133 SDRAM in TSOP packages. This 168-pin DIMM uses gold contact fingers and requires +3.3V. The electrical and mechanical specifications are as follows: FEATURES: CLK Cycle Time (tCC) Row Cycle Time (tRC) CLK to Output (tSAC) Single Power Supply of Power UL Rating min. = 7.5ns (CAS Latency = 3) / max. = 1000ns 65ns max. = 5.4ns (CAS Latency = 3) +3.3V (+/- .3V) 4.140 W (operating) 94 V - 0 Note: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. However, in no configuration will the module height exceed 1.375" (34.92mm). Units : Inches (millimeters) 5.250 (133.350) R 0.079 (R 2.000) 0.175 (4.45) 0.157 ± 0.004 (4.000 ± 0.100 ) 0.350 (8.890) B A 0.250 (6.350) 0.250 (6.350) .450 (11.430) C 1.450 (36.830) 2.150 (54.61) 0.100Min (2.540Min) .118DIA ± .004 (3.000DIA ± .100) 0.700 (17.780) 0.118 (3.000) 1.375 (34.925) 0.387 ± 0.062 (9.84 ± 1.59) 0.089 (2.26) 5.014 (127.350) 0.118 (3.000) 4.550 (115.57) 0.200 Min (5.08 Min) 0.150 Max (3.81 Max) 0.050 ± 0.0039 (1.270 ± 0.10) Figure 1: KVR133X64C3/512 168-Pin SDRAM Module Document No. VALUERAM0018-001.B00 05/09/02