Download BDI Fin
Transcript
assembly instructions F in 1106 and 1110 Component List A - 4mm Hex Driver x1 bdiusa.com [email protected] Fin is engineered for easy assembly. Carefully follow this procedure to prevent any damage. Placement and Maintenance Fin is designed for indoor use on level floors. Clean glass with glass B - Phillips Screwdriver cleaner, and steel parts and wood veneer with a moist cloth. x1 C - 2mm Hex Driver with Ball End x1 D - Wood Base x 1 E - Cap Screw x 6 F - Leg x 3 G - Glide x 3 Step 1 Unpack and Identify Unpack and identify the components at left. The assembly workspace should be a non-marring surface such as carpet. For missing hardware pieces, please contact BDI Customer Service at customerservice@ bdiusa.com. For all other concerns, please contact your BDI Retailer. Step 2 Install legs Wood direction/orientation is critical. After locating the “BOTTOM SIDE” label on wood base, attach Legs (I) to bottom side with Cap Screw (E) using the 4mm Hex Driver (A) and then snap in Glides (G). Install Glass Support Tube (H) to top edge of wood part using the 4mm Hex Driver (A). NOTE: The Glass Support Tubes have a small set screw just below the open end. H - Glass Support Tube x 3 Glass Support Tubes have Set Screw (K) just below open end. A E I - Plastic Set Screw for Glass Shelf x3 H J - Glass Shelf x 1 K - Set Screw x 3 Pre-installed in Glass Support Tubes (H) M - Glass Top x 1 F E F F A Designed by Cristian Wicha. These distinctive product configurations are protected by US and international patents, trade dress, and/or copyright laws. BDI is trademark of Becker Designed, Inc. All rights reserved. ©2010, BDI Made in China. 11061110REV07012010v4 1 G G Step 3 Install shelf. Using the Phillips Screwdriver (B), install Glass Shelf (J) with Plastic Screws (I) to the pre-installed shelf supports as shown below. I B Step 4 Install table top. Using the 2mm Hex Driver (C) and Set Screw (K), install Table Top (M) as shown below. J M C K H 2 assembly instructions bdiusa.com [email protected]