Download Intimus PacMate

GB
PacMate
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
INSTALLATION
INSTALLATION INSTRUCTIONS:
Proceed as follows when installing and setting
up the machine:
1. Place the machine on a table so that the two
feet at the back are lined up with the edge of
the table.
Do not worry: the machine‘s centre of gravity
is always located over the table and it cannot
tip over the edge.
2. Pull the metal frame for the waste bag out as
far as possible (fig. 3)
3. Hang the plastic bag into the frame and secure
it to the two hooks at the side of the housing.
Then fold the edge over the frame from the
inside out (fig. 4).
fig. 3
fig. 4
MALFUNCTION / MAINTENANCE
PAPER JAM:
If too much materials is fed to the cutting system
the cutting system will jam. Proceed as follows:
- Operate the rocker switch (1) (fig. 1) to position
„bowed arrow“.
- The cutting system runs in reverse and free up
excess materials.
- Remove excess materials from the machine and
continue processing with a smaller amount of
material.
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the machine off with
the rocker switch (1) (fig. 1) (position „0“). Allow
the motor to cool down for 15 to 20 minutes
(depending upon room temperature) and then
continue shredding.
DISPOSING
CHECKLIST IN CASE OF MALFUNCTIONS:
If the device does not function, check the following:
- is the plug connected to the mains?
- is the rocker switch (1) on?
- Is there a material jam in the inlet chute?
Follow the instructions under „MATERIAL JAM
IN THE INLET CHUTE“.
- has the motor been overloaded?
Wait until the motor has cooled, and then restart.
If none of the above applies, please contact
your dealer.
No structurel modifications may be
carried out!
In case of non-observance, the operation permission expires.
ACCESSORIES
Description
Order-No.
Plastic bag, 440 x 390 x 1100 x 0,03 mm
99951
Note: For orders of special accessories and spare parts, please contact your dealer.
5
DISPOSING OF THE MACHINE:
Dispose of the machine in an
environmentally sound fashion at the end
of its useful service life. Do not dispose of
any of the parts included in the machine
or its packaging with household trash.
TECHNICAL DATA
Cutting width:
Cutting capacity:
Inlet guide:
Working width:
Cutting speed:
Power consumption:
Intermittent service:
Supply voltage:
Pre-fusing:
230V:
240V:
100V-120V:
Width:
Depht:
Height:
Noise level:
Weight:
3.8x112 mm
1 layer corrugated
board quality 1.2
(max. thickness of
cor. boards 18 mm)
10 mm
400 mm
0.13 m/sec.
1.1 kW
30 min – 15 min
230V/50Hz
240V/50Hz
120V/60Hz
100V/50/60Hz
16 A
13 A
20 A
525 mm
300 mm
375 mm
approx. 61 dB(A)
approx. 38 kg