Download XciteRC Sand Rail

Chassis tuning guide
steering arm (30201011) press against the front uprights (30201012) which may damage the steering
servo!
EN
-
+
+
+
After the ride:
1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
OFF
WARNING: disconnect the drive battery and remove it from the model – fire hazard!
2.
WARNING: the motor of the Sand Rail may get very hot during operation. Allow to cool down minimum 20
minutes before the next start to avoid damage. Fire hazard!
Chassis Tuning Guide
On your Sand Rail chassis two parameters can be adjusted: the toe of the front axle and the camber of both
axles.
Toe-in:
Front Turning Linkage Set
toe-out
the setting is done via the steering linkage. More toe-in gives a
zero toe
better directional stability, but also poorer turn in at corner entry,
and generally a less direct steering.
toe-in
More toe-out effects a direct response to steering commands
and more aggressivity at corner entry, but is also more difficult
to control.
A neutral setting reduces tire wear and gives a neutral handling.
toe-in
zero toe
toe-out
Sand Rail
Front Turning Linkage Set
23