Download WOLF-Garten AMBITION V 303 E

Operation
Operating times
 Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief E
– Settings pos. „2, 3, 4“ are not required until the blades/aerator tines are worn. Depending on the degree of wear, gradually set the blades lower, starting at pos. „2“.
 Reducing the working depth (a, c)
3
 Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
 The machine operates from any normal household mains supply.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
 We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Adjust operating depth J
1
1
3
Caution! Only with motor switched off and non-mowing
scarifying / aerating roller.
Caution! The working depth must be set correctly before the unit is used for the first time. The hight adjustment lever may be moved to the first working depth
setting only (position „1“)
Note
If the blades/aerator tines are worn, the working depth must
be readjusted subsequently. An optimum working depth is
obtained when the blades/aerator tines of the cutter are inserted 2–3 mm into the ground.
If the working depth is too great, the unit may be overloaded
and cause damage. Therefore, ensure that the working
depth is set correctly.
 Increasing the working depth (cutters towards the
ground) (a, b)
– Set height adjustment lever (depending on model) according to wear.
Scarifying / aerating test:
 Set height adjustment lever in working position „1, 2, 3,
4“ J .
 Start tool G
 On hearing stones being hit or blocking of the motor immediately switch off tool
 Reducing the working depth J : Set height adjustment lever in working position „1, 2, 3, 4“.
 Start scarifying / aerating test again
 When used regularly the working depth may be adjusted according to the wear of the blade (+).
Recommended working heights
 well kept lawns with stone-free, soft ground
– Set tool exactly to ground height
 stony, untidy lawns
– Set tool to ground height
– Increase working height if stones are thrown up
 unkempt, extremely mossy lawns
– Start with a high working height
– Do not overload appliance (reduce working height if motor
blocks)
– Cut vertically and crossways several times
Scarifying / aerating G
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
3. Switch-off motor: Release bar (2).
1
Important:
Place the cable firmly off the lawn or on the already cut side
of the lawn when starting to mow.
Maintenance
General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
 pull out the power plug.
 Do not touch running blades.
 Store unit in a dry room.
3
We recommend
Allow a WOLF-Garten-service centre to check the unit in the
autumn.
Cleaning
 Clean the unit thoroughly with a brush after each use.
 Do not spray with water.
12
G