Download Ferm SGM1008
Transcript
EN 4. MAINTENANCE Make sure that the machine is not live when carrying out maintenance work on the motor. This machine has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper machine care and regular cleaning. Troubleshooting 1. Motor hums but does not spray or irregular spraying • Wornswirlhead. • Replace swirl head. • Pickuppipenotintherightposition. • Re-adjust pick up pipe. • Blockedpickuppipe. • Clean with thinner. • Blockednozzle. • Clean nozzle. • Blockedfilter. • Clean with thinner. • Controlknobneedsadjustment. • Adjust. 2. Atomization is not good • Volumeadjustmentisnotcorrect. • Adjust. • Painttoothick. • Check viscosity of the paint. 3. Over painting • Spraygunnotclean,ornotlubricated, resulting in piston being stuck in cylinder. • Disassemble spray gun and clean with thinner. • Toomuchpaint. • Adjust the volume clockwise to reduce spraying. Two thin coats are better then one thick coat. • Viscositytoolow. • Check viscosity. 4. Motor louder than normal • Spraygunnotclean,ornotlubricated, resulting in piston being stuck in cylinder. • Disassemble spray gun and clean with thinner. 5. No spray, no sound • Noelectricity. • Check power supply. 6. Operating sound not right • Pooroutputadjustment. • Re-adjust. • Notenoughpaintinthecontainerresultingin air being sucked in. • Refill with paint. • Notdilutingproperlyornotpassingpickup pipe completely. • Check pick up pipe and viscosity level. 7. “Orange Skin” excessive fogging • Incorrectsolventisused. • Use correct solvent. • Sprayguntoofarfromthesurface. • Hold spray gun closer to the object. • Painttoothick. • Thin the paint. Cleaning and maintenance Fig. G Always remember to disconnect from the mains supply before cleaning the spray gun or paint container. Itisessentialthatthesprayguniscleaned thoroughly after every use. Failure to clean it will almost certainly result in blockages and it may not operate when you next come to use it! The guarantee does not cover cleaning a sprayer that has not been properly cleaned by the user. The following action must be taken after every use: • Emptyanyremainingmaterialfromthe container. • Cleanthecontainerthoroughlywiththethinner thatwas used. • Poursomethinnerintothecontainerand spray through the spray gun until only clean thinner is coming out of the nozzle. • Thoroughlycleanthepaintpickuppipeand filterwiththinner. • Cleanthebasketandnozzleandremoveany other debris or paint that remains. • Turnthespraygunupsidedownandapplya few drops of light oil to the two apertures (F). This will lubricate the piston and cylinder. Ifyourspraygunshouldrequireextrainternal cleaning,itmaybenecessarytodisassembleit.If so the following action should be taken: • Removetheplugfromthemainssocket. 7
This document in other languages
- français: Ferm SGM1008
- español: Ferm SGM1008
- Deutsch: Ferm SGM1008
- русский: Ferm SGM1008
- Nederlands: Ferm SGM1008
- dansk: Ferm SGM1008
- polski: Ferm SGM1008
- čeština: Ferm SGM1008
- svenska: Ferm SGM1008
- italiano: Ferm SGM1008
- português: Ferm SGM1008
- suomi: Ferm SGM1008