Transcript
8 5 6 7 4 REPLACEMENT PARTS REPLACING A LOST OR DAMAGED PART: D 1 UT-X-SD-KIT1 HARDWARE CONTENTS INSTALLATION INSTRUCTIONS: 1. 2. 3. 2 3 Refer to UT-X-SD exploded view shown below and identify item number of lost or damaged part(s). Select appropriate part from UT-X-SD-KIT1 Hardware Contents and replace accordingly. Once replaced, adjust side hold downs and front/rear fences as needed according to the set-up instructions outlined in the owner's manual supplied with this kit. NOTE: Retain all unused hardware for future use. ITEM NO. HAVIS PART NUMBER QTY. BRACKET, FRONT FENCE, RH BRACKET, FRONT FENCE LH BRACKET, OFFSET REAR FENCE BRACKET, OFFSET HOLD DOWN LUG CAP, VINYL, BLACK, 0.69" X 0.62" CAP, VINYL, BLACK, 0.45" X 0.5" CAP, VINYL, BLACK, 0.9" X 0.5" SCREW, BUTTON HEAD, T25 PIN-IN-TORX, #10-32 X 0.5" LONG WASHER, BELLEVILLE, SERRATED, #10 SCREW SIZE NUT, HEX LOCK, NYLON INSERT, #10-32 WASHER, FLAT, 1/4" SCREW SIZE UT-0081-SM UT-0080-SM UT-0079-SM UT-0078-SM HW-CA-0004/GSM41122 HW-CA-0001/GSM41120 HW-CA-0005/GSM41123 HW-BH-0079/GSM33330 HW-SW-1262/GSM31089 HW-NN-0902/GSM30015 HW-SW-1206/GSM31085 1 1 2 2 4 4 2 4 4 2 2 TAMPER-RESISTANT T25 PIN-IN-TORX KEY HW-AW-0006/GSM50261 1 DESCRIPTION 1 2 3 4 5 6 7 8 9 10 11 D TOOLS 12 SIDE HOLD DOWN 4 C 11 7 REAR FENCE 6 12 5 C 2 3 1 FRONT FENCE LH 9 B 7 8 2 B 10 5 5 10 3 11 A FRONT FENCE RH UT-X-SD-KIT1_INST 7 6 9 5 DATE PRODUCT I.D. UT-X-SD-KIT1 03-18-11 PRODUCT NAME 8 WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER, PRODUCT DESCRIPTION IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE PARTS REPLACEMENT KIT FOR OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN UNIVERSAL TRAY ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE OPERATING VEHICLE. DRAWING NUMBER: 8 6 6 1 4 4 3 UT-X-SD REPLACEMENT KIT1 WEIGHT: (LBS) UT-X-SD REV. DATE 03-25-11 1-800-524-9900 WWW.HAVIS.COM 2 1 F-730-019 REV A A
