Download Intex 28645EG water pump

(195PO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
SETUP INSTRUCTIONS (continued)
4. In a clockwise motion screw filter housing nut (17) onto the motor water inlet (See
drawings 12.1 & 12.2).
12.2
12.1
17
17
5. Replace the basket (16) and leaf trap cover (14) back to the pre-filter housing (See
drawings 13.1 & 13.2).
13.1
13.2
14
35
16
19
Sand tank installation:
1.
2.
3.
Place the tank support base on the selected location.
Place the tank on the tank support base (See drawing 14.1).
Connect the motor pre-filtering assembly unit to the tank support base (See drawing 14.2).
NOTE: Ensure the pre-filter housing water inlet hose connection is facing towards the pool.
IMPORTANT: Some countries, especially in the European community, require the
product to be secured to the ground or to a base in a permanent upright position.
Check your local authorities to determine if there is a regulation in your area
regarding above-the-ground swimming pool filter-pumps. If yes, then the product
can be mounted to a platform using the two holes located in the base.
See drawing 14.3.
The product can be mounted on a cement base or onto a wooden plat form to
prevent accidental falling over.
• The mounting holes are 6.4 mm in diameter and spaced 100 mm for model
SF80110 (spaced 115 mm for model SF70110 & SF60110) apart.
• Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
14.1
14.2
14.3
Model SF80110: 100 mm
Model SF70110 & 60110: 115 mm
SAVE THESE INSTRUCTIONS
Page 9
195
PO