Download Amer Networks SS2GD8ip

Function name:
ACE Configuration
Function description:
The switch ACL function support up to 128 Access Control Entries (ACEs),
using the shared 128 ACEs for ingress classification. You can create an ACE
and assign this ACE for each port with <Any> or assign this ACE for a policy
or assign this ACE for a port. There are 8 policies, each port can select one of
policy, then decides which of the Permit/Deny, Rate Limitation and Port Copy
actions would take according to the ACL configuration packet’s IPv4,
EtherType, ARP Protocol, MAC Parameters and VLAN parameters.
Parameter description:
Ingress Port:
Range: Any / Policy 1-8 / Port 1-8
Any: Apply this ACE rule for each port ingress classification
Policy 1-8: Apply this ACE rule for specific policy
Port 1-24: Apply this ACE rule for specific port ingress classification
IP Protocol Filter:
Range: Any / Ethernet Type / ARP / IPv4
Any: It is including all frame type
Ethernet Type: It is including all Ethernet frame type
ARP: It is including all ARP protocol frame type
IPv4: It is including all IPv4 protocol frame type
MAC Parameters: (When Frame Type = Any)
DMAC Filter:
Range: Any / MC / BC / UC
Any: It is including all destination MAC address
MC: It is including all Multicast MAC address
BC: It is including all Broadcast MAC address
UC: It is including all Unicast MAC address
MAC Parameters: (When Frame Type = Ethernet Type)
SMAC Filter:
Range: Any / Specific
Any: It is including all source MAC address
Specific: It is according to SMAC Value specific the source MAC
address
DMAC Filter:
Range: Any / MC / BC / UC / Specific
Any: It is including all destination MAC address
MC: It is including all Multicast MAC address
BC: It is including all Broadcast MAC address
UC: It is including all Unicast MAC address
Specific: It is according to DMAC Value specific the destination
MAC address
131
Publication date: Dec., 2010
Revision B1