Download Chicco Together
Transcript
materials and fabric to fade. • WARNING: Do not use the product if any parts are broken, torn or missing. • WARNING: when it is not being used, the stroller should be kept out of children’s reach. • WARNING This product is not suitable for running or skating. • WARNING: Prevent the stroller from coming into contact with salt water. It may cause the formation of rust. • WARNING: Do not use the stroller on the beach. • WARNING: this product must only be used by an adult. tray towards the handlebar until you hear it click into place (diag. 1B). Check that the closing mechanism wire does not interfere with the carry-all tray fasteners. How to open the stroller WARNING: before you start, check that your children are at a safe distance. Ensure that during these operations the moving parts of the stroller do not come into contact with your child. 2. Once the carry-all tray has been fastened to the frame, move the sliding button on the tray (diag. 2A) to the left whilst pressing the centre button and raising the handle (diag. 2B); now open the stroller by using your other hand to push the front section of the frame downwards, until you hear it click into place (diag. 2C). Make sure the stroller is open properly before proceeding any further. 3. The rear seat on the stroller is fitted with a footrest. Once the stroller is open, lower the footrest (diag. 3). 4. To adjust the height of the handlebar, press the two side buttons (diag. 4) at the same time and move the handlebar to the required position. • WARNING Check that the pram body or seat unit attachment devices are correctly engaged before use. CLEANING AND MAINTENANCE The cleaning and maintenance of this product must be carried out on a regular basis by the user. The cleaning and maintenance of the stroller must only be carried out by an adult. Basket 5. The stroller comes with a practical carry-all basket. To assemble the basket, slide the U-shaped tube into the tube ends on the back of the stroller, as seen in diag. 5A. The U-shaped tube is fitted correctly when you see the 2 grey rods on the bottom, protruding from the holes below the stroller frame tubes and you hear them click into place. To finish, fasten the fabric to the tube using the press studs (diag. 5B). Never use the carry-all basket without the supports inserted properly. Always remove all contents from the basket before you close the stroller. 6. You can also open the zip (diag. 6) on the back of the basket to access it more easily. CLEANING The cover cannot be removed. Clean all fabric parts with a damp sponge and neutral detergent. Please refer to the care labels for instructions on how to clean the fabric parts. Below are the cleaning symbols and their meanings: Wash by hand in cold water Do not bleach Do not tumble dry Fitting the back wheels 7. Parts needed to fit the back wheels: see diag. 7. 8. Remove the caps from the ends of the rear axle, then slot the rear axle onto the frame, until you hear it click into place (diag. 8). WARNING: always check the rear axle is fitted properly before using the stroller. 9. To assemble the wheels on the rear axle A) follow the instructions in the correct order (see diag. 9A): - the wheel B) - the washer C) - the spring pin D) - the cap E) Make sure you insert the fastening spring pin as indicated in the diagram: the flat side must be inserted in the whole on the axle, whilst the closed end of the spring pin must be facing outwards (diag. 9B). Repeat the operation to assemble the other wheel, following the instructions in the same order. Do not iron Do not dry clean Periodically wipe clean plastic parts with a soft damp cloth. Always dry the metal parts to prevent the formation of rust if the stroller has come into contact with water. MAINTENANCE Lubricate the moving parts only if necessary, with the light application of a silicone based lubricant. Regularly check the condition of the wheels and, keep them clean of dust and sand. To avoid friction that may prevent the correct operation of the stroller, ensure that all the movable plastic parts placed along the metal frame are clean of dust, dirt or sand. Keep the stroller in a dry place. GENERAL INSTRUCTIONS ASSEMBLING AND OPENING THE STROLLER Carry-all tray 1. The mechanism which opens and closes the stroller is fitted inside the carry-all tray. The 2 tabs on the end of the carry-all tray are used to fasten it to the stroller frame: slide the 2 tabs along the slots inside the handlebar (diag. 1A) and push the Fitting the front wheels 10. Slot the front wheel block onto the stroller frame as seen in diag. 10, until you hear it click into place. Repeat this procedure for the other wheel block. WARNING: check that the wheels are fitted correctly. 21
This document in other languages
- français: Chicco Together
- español: Chicco Together
- Deutsch: Chicco Together
- русский: Chicco Together
- Nederlands: Chicco Together
- polski: Chicco Together
- čeština: Chicco Together
- svenska: Chicco Together
- italiano: Chicco Together
- português: Chicco Together
- Türkçe: Chicco Together