Download Peerless SP735P flat panel wall mount
Transcript
Mounting and Removing Flat Panel Display WARNING • Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel displays. 3 Hook adapter brackets (B) onto adapter plate (A). Turn security screws, using phillips screwdriver, clockwise at least six times to prevent display from being removed as shown in cross section of fig. 3.1. B A NOTE: To lock the display down, tighten safety/ security screws to wall plate as shown in cross section. SECURITY SCREWS To remove display from mount, loosen safety/ security screws, swing display away from mount, and lift display off of mount. A B CAUTION CROSS SECTION fig 3.1 • Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque. 4 If more or less tension is desired in tilt mechanism, remove snap caps as shown in detail 1. Insert a flat head screwdriver into slot and pry cap away from tilt mechanism. To adjust tilt, tighten or loosen socket screw no more than half a turn using 5 mm allen wrench (M). To adjust roll (5° left or right), tighten or loosen 10-32 x 1/2" phillips screw. 10-32 X 1/2" SCREW SOCKET SCREW WARNING SNAP CAP • If screws become loose over time, tighten screws as necessary. Tighten screws to 50 in • lbs (5.6 N.M.) maximum torque. SLOT DETAIL 1 8 of 42 ISSUED: 02-15-10 SHEET #: 095-9316-2 08-02-11
This document in other languages
- français: Peerless SP735P
- español: Peerless SP735P
- Deutsch: Peerless SP735P