Download Graco Nautilus

8.6 To Install Locking Clip
1. Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the
shoulder belt.
:KLOHSXVKLQJGRZQRQVHDWSLQFKWKHWZRVWUDSVWRJHWKHUEHKLQGWKHEXFNOHWRQJXH8QEXFNOH
the belt without allowing it to slip.
3. Attach locking clip to lap and shoulder belts as shown ™.
4. Rebuckle belt. Check that lap belt does not move
E\SXOOLQJKDUG,IEHOWORRVHQVRUOHQJWKHQVUHSHDW
procedure.
Remove locking clip when not using child restraint. Store
under it’s tab on the rear of seat.
Test installation to see if child restraint is secure.
,IQRWVHFXUHDGGLWLRQDOEHOWWLJKWHQLQJPD\EHUHTXLUHG
• Unbuckle vehicle seat belt.
• Hold belts together and remove locking clip.
• Shorten length of lap belt portion slightly by pulling belt
through latch plate. Re-attach locking clip.
• Buckle vehicle seat belt. Press child restraint further down
into vehicle seat cushion to help buckle vehicle seat belt. Test
LQVWDOODWLRQWRVHHLIFKLOGUHVWUDLQWLVVHFXUH,IQRWVHFXUH
repeat above steps until secure.
21
™
1” (2.5 cm)