Download Da-Lite Advantage Electrol

ADVANTAGE® ELECTROL® INSTALLATION FOR 120V SCREENS
120V WIRING DIAGRAM WITH OPTIONAL BUILT-IN
VIDEO PROJECTOR INTERFACE
120V WIRING DIAGRAM FOR
STANDARD WALL SWITCH
GREEN (GROUND)
BLACK (DOWN)
WHITE (COMMON)
RED (UP)
BLACK (HOT)
WHITE (COMMON)
WHITE
JUNCTION BOX
LOCATED IN LEFT
ENDCAP
RED
BLACK
GREEN
MOTOR
110VOLT AC/60HZ
POWER SOURCE
WHITE
RED (UP)
BLACK (DOWN)
GREEN (GROUND)
SPDT SWITCH WITH
CENTER OFF
FRONT OF
WALL SWITCH
AC (COMMON)
BLACK
UP
UP
STOP
AC HOT 120VAC 60HZ 1 AMP
OFF
THIS SWITCH CAN NOT
BE USED WITH LVC.
DOWN
BLACK/YELLOW
RED
DOWN
RED
BLACK
WHITE
BACK OF WALL
SWITCH
NOTE: A SINGLE SWITCH CANNOT BE USED TO OPERATE MORE THAN
ONE SCREEN. CONTACT THE FACTORY FOR FURTHER
INFORMATION.
RED
BLACK
FIGURE 3
FIGURE 4
5/12 VOLT SCREEN
TRIGGER ON PROJECTOR
!
s
CAUTION: The projector must be turned off before connecting the trigger wires to the projector. Failure to do so may damage the
controller.
1. Use 2-conductor 20-24 gauge wire to extend the low voltage connection from the projector’s 5 or 12-volt screen trigger output to the length
required to reach the VPI. When extending the low voltage connection from the projector’s screen trigger output, be sure to maintain the proper
polarity. The red wire from the VPI is the “signal” and the black wire from the VPI is the “ground”.
2. Connect the wires from the VPI that are labeled “Low Voltage Connection” to the end of the extended screen trigger wires above.
RJ-14 PIN-OUTS
120V WIRING DIAGRAM
WITH OPTIONAL BUILT-IN
LOW VOLTAGE CONTROL
(TAB IS FACING UP)
+12V
BUS (RP DATA)
WHITE
BUS (RP DATA)
RQ DATA
+5V
GND
GREEN
RED
BLACK
RQ DATA
+5V
GND
RQ CLOCK
RJ-22
JACK
LED
Supplied RJ-14 cable
STO
P
N
RJ-45 JACK
DOWN LIMIT
TACTILE BUTTON
FRONT OF
WALL SWITCH
GREEN
RED
BLACK
WHITE
(TAB IS FACING UP)
DRY CONTACTS
MANUAL 2
+12V
BROWN
BLUE
BUS (RP DATA)
YELLOW
RQ DATA
+5V
GND
DOW
YELLOW
Standard RJ-22 can be used in place of RJ-14
CO
RJ-22
JACK
BLUE
RJ-45 PIN-OUTS
RJ-22
OUTPUT
RJ-22
INPUTS
UP
DO (RED
WN )
(BL
M
AC
(W
HIT K)
E)
UP LIMIT
TACTILE BUTTON
UP
RJ-22 PIN-OUTS
(TAB IS FACING UP)
RJ-45
RECEPTACLE
DATA
CABLE
GREEN
RED
BLACK
RQ CLOCK
ORANGE
MANUAL 1
PURPLE
BACK OF
WALL SWITCH
POWER WIRE
IMPORTANT Note:
The wall switch is REQUIRED to make any limit switch
adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or
provide a 3-conductor connection that is accessible.
GREEN (GROUND)
BLACK (HOT)
WHITE (COMMON)
GROUND–MUST BE
CONNECTED TO
BUILDING GROUND
POWER INPUT 120VAC / 60HZ
2
FIGURE 5