Download Axis P3301 Nework Camera

Transcript
AXIS P3301
Overview
Status
indicator
(LED)
Dome casing
Camera unit
Microphone
Cover
plates
Control
button
I/O terminal
connector
Power
connector
Power
indicator
(LED)
Network
indicator
(LED)
Network
connector
and PoE
Audio out
Audio in
Serial number (S/N)
The serial number is required during the installation.
Please make a note of the serial number and retain
for future reference.
Microphone - built-in microphone. This can be disabled by inserting a plug in the 'Audio in' connector.
Power Connector - for connection of the PS-H power adapter (included).
I/O Connector - the I/O terminal connector provides the physical interface to one transistor output, one digital input and an
auxiliary connection point for DC power. For more information, see The I/O Terminal Connector, on page 37.
Network Connector - The camera connects to the network via a standard network connector. Supporting NWay, the camera
detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). Supporting PoE (Power over Ethernet), the
camera can be powered directly from the network cabling.
Audio Out - audio output (line level), which can be connected to a public address (PA) system or an active speaker with a
built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.
Audio In - a 3.5 mm input for a mono microphone, or for a line-in mono signal (a stereo signal from line-in uses the left
channel).
Serial Number Label - the serial number may be required during installation.
Control Button - press this button until the status LED blinks green to install the camera using an AVHS service (see page
30), or the AXIS Internet Dynamic DNS Service described on page 31. To restore the factory default settings using the control
button, follow the instructions Resetting to the Factory Default Settings, on page 36.
5