Download CVA100-2 - Manual
Transcript
2 Setup 2.1 Setup Precautions CAUTION: Before installing your amplifier, make sure that you have read the Important Safety Precautions at the beginning of this manual. 2.2 Rackmount Installation The CVA100-2 amplifier takes up only 1/2 of a standard 19” rack unit. While it is not necessary to rackmount your CVA100-2 amplifier, there are two options available if you would like to do so : a single rackmount or a double-rackmount. NOTE: Regardless of which rackmount option is used, the 4 adhesive rubber feet must be removed from the bottom of the unit. 2.2.1 Single Rackmount A single CVA100-2 amplifier can be mounted on one rack unit with the RMK-70-S rackmount kit. The kit includes 2 brackets which will center the CVA100-2 on a single rack unit. 2.2.2 Dual Rackmount Two CVA100-2 amplifiers can be mounted on one rack unit with the RMK-70-D rackmount kit. The kit will connect the two amplifiers and center them on a single rack unit. Single Rackmount with RMK-70-S CVA100-2 #1 Sig/Clip Power/Active #2 Dual Rackmount with RMK-70-D CVA100-2 #1 6 Sig/Clip #2 Power/Active CVA100-2 #1 Sig/Clip #2 Power/Active