Download mds_nxos_rel_notes_4..

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m .
•
CSCsr69166
Symptom: Solaris Windows Manager does not resize windows correctly which effects some Device
Manager screens.
Workaround: This issue is resolved.
•
CSCsu23984
Symptom: Starting with MDS NX-OS 4.1(1), a password security feature was introduced that
allowed a user to enable a secure password standard. However, this feature was not being enforced
for SNMP users.
Workaround: This issue has been resolved.
•
CSCsu30034
Symptom: During and In Service Software Upgrade (ISSU), throughput statistics will not be
available from the switch undergoing an upgrade. This information will be not able available from
the CLI or Device Manager via SNMP.
Workaround: This issue is resolved.
•
CSCsu37199
Symptom: Errors on the management port (mgmt0 or eth1) may be seen in the output of the show
logging log command.
%KERN-3-SYSTEM_MSG: eth1: error in ethGetNextRxBuf %KERN-3-SYSTEM_MSG: eth1: stop
internals failed %KERN-3-SYSTEM_MSG: eth1: error in rx %KERN-3-SYSTEM_MSG: eth1: error
in rx %KERN-3-SYSTEM_MSG: eth1: error in rx %KERN-3-SYSTEM_MSG: eth1: error in rx
%KERN-3-SYSTEM_MSG: eth1: error in rx
In rare cases, this issue may result in a kernel panic which causes a supervisor switchover.
Workaround: This issue is resolved.
•
CSCsu38297
Symptom: When performing a Veritas Netbackup database backup (such as a NB Catalog Backup),
that requires a separate tape cartridge from the scratch pool (other than regular data backup tapes),
the tape barcode is shown as Unknown in the Cisco Key Management Center.
Workaround: This issue is resolved.
•
CSCsu41818
Symptom: Following a system reload with a startup-configuration that had scheduler
configurations, none of the scheduler CLI commands are available. When upgrading to Cisco
SAN-OS 3.2(1c) from a earlier version, the scheduler is enabled by default.
Workaround: This issue is resolved.
•
CSCsu42003
Symptom: When an FCIP tunnel is configured with IPsec between an MDS 9222i switch and an
MDS 9216i switch, it fails to come up if an ACL with TCP permit is configured. This causes a
mismatch and causes the security association (SA) policy creation to fail in IPsec on the supervisor.
Workaround: This issue is resolved.
•
CSCsu53299
Symptom: When reloading a switch, a timing condition may cause CFS to enter the handshake
before the Routing Information Base (RIB) does. In this instance, CFS will not see any peers, and
as a result, CFS-based applications will not communicate with the rest of the fabric.
Workaround: This issue is resolved.
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(3a)
OL-17675-05
51