Download MOSFET POWER AMPLIFIERS

FEATURES
ANO BENEFITS
OC Off set Protection
This circuit protects the output of the amplifier against DC voltage. If for some reason DC
voltage is detected at the output stage, the amplifier will shut down protecting the speakers
from direct current.
Bass Boost
For added low frequency
bass boost 0 45Hz.
performance
the an
Line Out
One set of full range line outputs have been pt
amplifiers in the system.
Short Circuit Protection
Subsonic Filter
The circuit protects the amplifier from damage due to a short found in the speakers or wiring.
If one of the speakers or its wiring comes in contact with ground, the amplifier will shut down.
To resume normal operation, correct the problem and turn the head unit off, then back on. The
amplifier will reset and play again.
Thermal
(CL1200
& CL600M On
A subsonic filter has been provided to filter
audible range. Once engaged this feature help
since power is not wasted reproducing frequc
works in conjunction with the Low-pass crosso\
Protection
Power Fusing
To protect the amplifier circuitry against damage caused by prolonged exposure to high
temperatures, a thermal protection circuit is activated if the amplifier reaches excessively
high operating temperature.
Once the thermal circuit is activated, the amplifier will shut
down to cool off. The Amplifier will automatically turn back on once it cools down to a safe
operating temperature.
Protection
Indicator
Once on, the
This red diagnostic L.E.D. indicates that the amplifier has gone into protection.
amplifier will have no output. To resume normal operation, turn head unit off and back on again.
If the amplifier immediately goes back into protection, check for high temperature,
short
circuitsor low impedance.
Tri Mode Capable
If so desired the amplifier may be run in stereo and mono at the same time. For example, this
feature would allow you to run a pair of mid and tweeters in stereo and a sub-woofer mono.
This protects
the amplif ier against short circu
Remote Turn-on
Automatically
turns amplifier on when connc
amplifier will turn on and off with the head uni
operates the reset circuit for the amplif ier’s
unit in order to reset protection circuits.
Power and Speaker
Heavy gauge bare wire distribution
transfer with minimal resistance.
Adjustable
Blocks
blocks
Input Sensitivity
Allows you to fine-tune
Built-in
Distribution
the level matching bet
Crossover
High Level Input
The Clarus amplifiers include a built-in variable **high and low pass crossovers. The crossover
features a variable frequency selection (40Hz N 500Hz) for precise high or low pass filtering.
**Except CL600M which has a 50 _ 120Hz low pass filter.
Allowing for integration
with “Factory
Sound !
Stable To 2 Ohm Stereo Mode
Stability
to 2 ohm in stereo mode, 4 ohms brid