Download Hydro-Probe SE User Guide
Transcript
Material calibration Chapter 5 Figure 28: Unscaled and Brix values entered into Hydro-Com Once a number of points have been entered into the list (Figure 28), the “Calculate Best Fit” button should be clicked. Figure 29: Starting point selector A pop-up menu (Figure 29) will display a choice of methods in which to calculate the line of best fit through your calibration points. Each method calculates the line of best fit slightly differently. Three methods are given to ensure that the best possible fit may be achieved. The most commonly used is, ‘Use default starting point’. The other two methods may also be tried and the results viewed by eye (Figure 30). Hydro-Probe SE User Guide HD0278 Rev 2.0.0 39