Download Data sheet 1 - Communications Solutions UK

QuickSpecs
HP ProLiant SL160s Generation 6 (G6)
Standard Features
Memory
Type
DDR3 Registered (RDIMM) or Unbuffered (UDIMM)
Standard (per server tray) Entry: 6GB (3 x 2GB) RDIMMs
Base: 12GB (3 x 4GB) RDIMMs
Performance: 24GB (6 x 4GB) RDIMMs
Maximum (RDIMM) (per 384GB (12 x 32GB) for Registered Memory configurations
server tray)
Maximum (UDIMM) (per 48GB (12 x 4GB) for Unbuffered Memory configurations
server tray)
NOTE: Depending on the memory configuration and processor model, the memory speed may run at
1333MHz, 1066MHz, or 800MHz. Please see the Online Memory Configuration Tool at:
www.hp.com/go/ddr3memory-configurator.
NOTE: Kits described as LP include Low Power DIMMs. For more information on ProLiant Energy
Efficient Features, see: www.hp.com/go/proliant-energy-efficient.
Network Controller
HP NC362i Integrated Dual Port Gigabit Server Adapter
Expansion Slots
NOTE: Up to two available PCI Express 2.0 slots: Optional Slot 1: Full height/half length x16 PCIExpress 2.0 and Optional Slot 2: low-profile internal only x4 PCI-Express 2.0. If the x4 internal slot is not
configured, the x16 slot can support a full-height/full length card.
Slot #
Technology
Bus
Connector
Bus
Device
Form
Notes
Width
Width*
Number*
No.**
Factor
Width
Number
No.
1
PCI-Express
x16
x16
1
0
Full
3.3 volts
2.0
Height/Full
Length***
2
PCI-Express
x4
x8
2
Low Profile,
2.0
Internal
Only
NOTE: All slots can accept universal keyed PCI cards.
* Default bus assignment. Inserting cards with PCI bridges may alter the actual bus assignment number.
** Slots are enumerated differently based on OS. MS OS's enumerate from lowest to highest Device ID
by bus (starting with the lowest bus).
*** If the x4 internal slot is configured, the x16 slot can only support a full-height/half length card.
Storage Controller
HP Embedded Smart Array B110i SATA RAID Controller (RAID 0, 1, 10)
NOTE: To enable RAID on Embedded SATA, use the HP Smart Array B110i SATA Raid controller, To
enable use of the B110i, enter the ROM based setup utility(RBSU). The option for enabling RAID can be
found in the advanced section of the RBSU. For additional details www.hp.com/go/SATARAID
NOTE: Transfer rate: 3.0 Gb/s SATA
NOTE: A HP Smart Array controller is required for SAS Hard Drives
NOTE: An external diskette drive, USB floppy drive key or virtual FDD using LO100 Advanced Pack is
needed to install storage controller drivers during a Windows operating system installation from a CD.
DA - 13949
Worldwide — Version 8 — September 26, 2011
Page 3