Download M2A-VM HDMI

Transcript
2.1.3
ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to go
through the long process of booting from a floppy disk and using a DOS‑based
utility. The EZ Flash 2 utility is built-in the BIOS chip so it is accessible by pressing
<Alt> + <F2> during the Power-On Self Tests (POST).
To update the BIOS using EZ Flash 2:
1.
2.
3.
Visit the ASUS website (www.asus.com) to download the latest BIOS file for
the motherboard.
Save the BIOS file to a floppy disk, then restart the system.
You can launch the EZ Flash 2 by two methods.
(1) Insert the floppy disk/USB flash disk that contains the BIOS file to the floppy disk drive or the USB port.
Press <Alt> + <F2> during POST to display the following.
ASUSTek EZ Flash 2 BIOS ROM Utility B318
FLASH TYPE: Winbond W39V080A 8Mb LPC
Current ROM
BOARD: M2A-VM HDMI
VER: 0104
DATE: 12/12/2006
Update ROM
BOARD: Unknown
VER: Unknown
DATE: Unknown
PATH: C:\
C
Note
[Enter] Select
[Tab]Switch
(2) Enter BIOS setup program. Go to the Tools menu to select EZ Flash 2 and press <Enter> to enable it.
4.
2-
[S] Save
[ESC]Exit
[Up/Down/Home/End] Move
You can switch between drives by pressing <Tab> before the correct file is found. Then press <Enter>.
When the correct BIOS file is found, EZ Flash 2 performs the BIOS update
process and automatically reboots the system when down.
•
This function can support devices such as USB flash disk, hard disk, or floppy disk with FAT32/16/12 format only.
•
Do not shut down or reset the system while updating the BIOS to prevent system boot failure!
Chapter 2: BIOS setup