Download NEC MultiSync MT1035 Plus Multimedia Projector
Transcript
23 5 RGB Input 2 Connector (Mini D-Sub 15 pin) Connect a Macintosh or compatible computer here using the signal cable and the monitor adapter that is supplied. Or connect your PC or other RGB equipment such as IBM or compatible computers. Use the signal cable that is supplied to connect to a PC. RGB 2 Audio Input Mini Jack 6 S–VIDEO INPUT PC CONTROL MOUSE OUTPUT AUDIO RGB MONITOR OUTPUT L/MONO RGB L/MONO VIDEO INPUT AUDIO R This is where you connect a second RGB audio output from a computer or another RGB source. 6 PC Control Port 7 INPUT 1 AUDIO RGB INPUT 2 8 REMOTE CONTROL INPUT AUDIO R AUDIO Use this port to connect your PC to control the MultiSync MT830+/ MT1030+/MT1035+ Projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, command references are on pages 103 to 106. 5 A cap is put on the port at the factory. Remove the cap when using the port. 7 Mouse Output Port Use this port to operate your computer’s mouse functions from the NEC MultiSync MT830+/MT1030+/MT1035+ remote control. When your computer is connected here, the remote sensors on the LCD projector cabinet will receive your mouse commands. 8 Remote Control Jack Connect your remote control cable here for wired operation. 9 Built-in Security Slot ( ) This security slot supports the MicroSaver® Security System. AC IN MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc. 9 13 INTRODUCTION 24